Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

laser cutting conditions for a Amada 3500

Thread starter tskar2
Start date Oct 4, 2010

Status: Not open for further replies.

Oct 4, 2010

tskar2

Industrial

Hi all. Im learning on the amada 3500 laser and would like to know if there are some books out with cutting conditions.
Having some trouble with thicker CRS messy cuts. There have been conditions put in machine but they are all guess work and not very good at that.