Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Layers - dimensions and section views

Status
Not open for further replies.

xcs05

Structural
Joined
Jun 14, 2010
Messages
1
Location
GB
I am using Solidworks 2009 and have a quick question about layers.

I know how to assign dimensions to a given layer, but was wondering if it is possible to assign the dimension value to one layer and the dimension extension lines to another.

I would also like to do the same thing with section views, i.e. assign the letters (A-A, B-B etc) to one layer and the section lines themselves to another.

Similarly, is it possible to assign the border of a table to one layer and the text itself to another?

Finally, is it possible to assign the text in a geometric tolerance to one layer whilst assigning the box and dimension lines to another.

Hope this makes sense. Any help much appreciated!
 
No
No
Yes ... This can be done when in the Edit Sheet mode
No
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top