Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Layout declare

Status
Not open for further replies.

pesamon

Automotive
Sep 29, 2006
10
ES
I need to declare a layout in all the parts of some assemblies.

What is the quickest way to do it? (Some of the parts have another layout declared already)

Thanks
 
Replies continue below

Recommended for you

I think the fastest way to do it is to make a mapkey. It will still require a bit of manual work but if you set up the mapkey right, it can open the parts from the assembly, declare the layout, close the window and reactivate the assembly. Then all you need to to is pick the next part and hit the mapkey again.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top