Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

LEADER NOTE LINE WEIGHT DEFAULT SETTING

Thread starter labrat1
Start date May 3, 2005

Status: Not open for further replies.

May 3, 2005

labrat1

Mechanical

When I use the leader note command from the annotate pull down menu the line weight always come up @ .05mm & does not print legably.
The AM_5 default layer is set to .25mm to no avail.
How do I set the default so I do not have to manually change each & every leader note to .25mm lnwt.?