I am using the output of Turck module to power a LED indicator. the output module has an M12 - 3 pin receptacle. I would normally run a single ended cordset assembly from the module and into a water tight enclore. Then i would solder the leads to the LED ass'y. For this application I can not use an enclosure. This means that the LED and it's connection will be in the open. Is there an adapter or cordset that will allow me to connect the output module to a standard LED indicator ass'y?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
LED TO M12 CORDSET
- Thread starter Moneil
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question