Ralph2
Industrial
- May 3, 2002
- 345
I have made a drawing of a simple part. On that drawing I have then sketched some circles and lines. Those lines show up as blue on my printed drawing.
How.. where, can I change them to be the same as the lines imported with my part?
How.. where, could I change the line thickness of any lines I draw on my drawing?
SW 2009
Thank you for your time
Ralph
How.. where, can I change them to be the same as the lines imported with my part?
How.. where, could I change the line thickness of any lines I draw on my drawing?
SW 2009
Thank you for your time
Ralph
![[thumbsup2]](/data/assets/smilies/thumbsup2.gif "[thumbsup2] [thumbsup2]")