Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Linear or Non-Linear FEA for plastic (material) snap-fit?
- Thread starter B_Jones
- Start date
![[ponder]](/data/assets/smilies/ponder.gif "[ponder] [ponder]")
Up to you to decide based on material/geometry/loading. In the past I've used nonlinear FEA due to:
Large displacements of the parts voiding small displacement assumption (geometrical non-linearity)
Snap fit analyses have generally involved contact between two or more parts (boundary non-linearity).
Plastic materials were typically non-linear under the operational loading conditions (material non-linearity)
Large displacements of the parts voiding small displacement assumption (geometrical non-linearity)
Snap fit analyses have generally involved contact between two or more parts (boundary non-linearity).
Plastic materials were typically non-linear under the operational loading conditions (material non-linearity)
IceBreakerSours
Bioengineer
What questions are you trying to ask of the model? What experimental data do you have to feed the model? How do you plan on validating the model?
*********************************************************
Are you new to this forum? If so, please read these FAQs:
*********************************************************
Are you new to this forum? If so, please read these FAQs:
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question