Lineweight positioning

[taffcad]

Someone has posed a question that has me stumped, they were shown it on a course but cant remember how to make the choice. Where is the selection that you can place the line weight postion so it is not on the centre line setting.

 

[borgunit]

Not quite sure what you mean. When you type in '_lweight , could this be what you want?

"Everybody is ignorant, only on different subjects." — Will Rogers

 

[taffcad]

Hi
Thanks for the reply.

The person told me its similar to using Multiline where you can set the position for the offset line to be either centre/top/bottom alignment. With the lineweight button selected highlighted then the preview lines are shown above/below or centred. I think the idea is so that close adjacent lines can still be shown? It maybe in the print options somewhere. Will check it out and post if I find it.

 

[borgunit]

Could this be what you are talking about?

http://www.cadtutor.net/michael/mc0308.html

"Everybody is ignorant, only on different subjects." — Will Rogers