I'm looking to pick parts from a mold as they eject and stack them in a box. The pattern in the mold is a symmetrical 4x4 with 5in centers. I would like to collapse the pattern to a 4x4 with 2.85in centers using some sort of linkage activated with air cylinder(s). Where is a good place to start?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Linkage to reduce spacing between centers.
- Thread starter gwsjr425
- Start date
MikeHalloran
Mechanical
You're proposing to fold the tree?
To do that, you need to put 'flats' in it, which will mess up the flow.
Maybe I'm not understanding what you want.
Mike Halloran
Pembroke Pines, FL, USA
To do that, you need to put 'flats' in it, which will mess up the flow.
Maybe I'm not understanding what you want.
Mike Halloran
Pembroke Pines, FL, USA
Programmable end of arm tooling: EOAT.
I would have thought it a trivial problem a non-programmable fixture for the folks who specialise in EOAT.
H
www.tynevalleyplastics.co.uk
It's ok to soar like an eagle, but weasels don't get sucked into jet engines.
I would have thought it a trivial problem a non-programmable fixture for the folks who specialise in EOAT.
H
www.tynevalleyplastics.co.uk
It's ok to soar like an eagle, but weasels don't get sucked into jet engines.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question