jetescamilla
Structural
My new employer uses SAP to model its bridge design I am just now learning how to pick it up. I have created my model have created also defined my loads. I went to Define->Load Cases and have created load names such as LL1, LL2, LL3, SDEAD...and so forth.
I have also appllied these load on the respective joints and members. of the frame.
Now, when I am trying to define the load combinations at defin->combination->and new combo I there is not LL1 there. There is LL2, LL3 and all the other loads I defined earlier. There is also a load called LIVE, which i did not create there.
My question is where did LL1 go? Any ideas?
I have also appllied these load on the respective joints and members. of the frame.
Now, when I am trying to define the load combinations at defin->combination->and new combo I there is not LL1 there. There is LL2, LL3 and all the other loads I defined earlier. There is also a load called LIVE, which i did not create there.
My question is where did LL1 go? Any ideas?
