We need to do Load Rating for H-20 load for Cast-in-Place Post tensioned box Girder two-span continuous bridge. We have software called "WINBDS" that performs load rating check for only flexural load. I will appreciate if any of you could let me know if you have used software that performs Load Rating check for the Shear Load. Thanks a lot.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
Load Rating for CIP-PT Box Girder Bridge
- Thread starter khshah
- Start date
checkout bridge11 by alan gordon
It's a standard load rating program for Washington State DOT. Very friendly...
It's a standard load rating program for Washington State DOT. Very friendly...
Most load ratings are done for the Federal database. Most of these ratings only included bending. Shear capacities are often considered to be sufficient without any analysis having been run.
California does a lot of load rating. To the best of my knowledge... shear capacities have never really been checked.
Dan
California does a lot of load rating. To the best of my knowledge... shear capacities have never really been checked.
Dan
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question