Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Loading Catia5 Models in Ford TeamCenter

Status
Not open for further replies.

pjune

Automotive
Jan 23, 2014
4
Using Ford TeamCenter 9 & Catia5_ver22: How can you load the drawing and models linked to the drawing at the same time? Instead of loading them separately.
 
Replies continue below

Recommended for you

Hi,

i think You can open or check out both the 3d model and 2D Drawing from the teamcenter into CATIA directly or ucan have a mapped drive where the files from the team center ( 2d and 3d ) get loaded and try dragging and dropping them into the catia session. Hope it helps.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor