Looking for a Microchip MCP1727T Cross Part

[danonboost]

Hello all,

Seems like the place for this..

I used a handful of MCP1727T-ADJE/MFs (LDO, 8-DFN 3x3, 1.5A) on a design and it's back from FAB. I was just informed there is a problem getting them....can't find them anywhere

I would use an MCP1726 but it can't handle the current (worst-case). The on/off and pgood feedback is a requirement. Microchip Direct has them arriving in July which is too late.

I've tried:
Linear
National
ON
TI
Fairchild

Any ideas or other manufacturers I should try?

Thanks,
dan

http://ww1.microchip.com/downloads/en/DeviceDoc/21999b.pdf

//1727

http://ww1.microchip.com/downloads/en/DeviceDoc/21936b.pdf

//1726

 

[GonzaloEE]

Try with some Japanese folks: Toshiba, etc.

 

[itsmoked]

WOw.. You even used the 3x3... A true glutton for punishment.

Annoying Microchip has no samples..

I'm sorry to hear of your plight. I have been there enough times that I never (NEVER) send a board out for fab without first having every single non-resistor part actually on order. That allows you to adjust your layout at the last minute to head off these nasty turns of event.

Keith Cress
kcress -

http://www.flaminsystems.com

 

[danonboost]

Yep, everything needed to be small, with 500 components on a 2.5x5" board I had no choice. I did my best so this would not happen, Microchip always has some stock (unless you count on it apparently); they had stock when I designed them in a few months ago.

Not really sure what to do at the moment. I may have to kludge something on there for the first few boards so the sw guys can get going.

 

[itsmoked]

I'm having no luck finding anything either..

Keith Cress
kcress -

http://www.flaminsystems.com

 

[danonboost]

Thanks for taking the time to help me look Keith.

 

[Madcow]

Do you need tape and reel?
MCP1727-ADJE/MF says 580 ready to ship on
Microchip direct.

 

[danonboost]

Awesome! They didn't last night; ordering immediately!

 

[itsmoked]

Man are you lucky.. As I can confirm there weren't any either.

Keith Cress
kcress -

http://www.flaminsystems.com

 

[GonzaloEE]

Looks like some folks have very good connections up there in Microchip