Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Looking for any reference of ms104 when applied to old BS standard

Status
Not open for further replies.
piperdg148

piperdg148

Mechanical
May 22, 2013
1
I am looking for anybody who can shed light on the following

The following statement appears on a fabrication drawing for an existing vessel

BS1503-224-490E-LT50 + MS104

I am trying to establish the meaning of MS104

Thanks.

Piperdg148
 
Status
Not open for further replies.

Similar threads

kelcgza
  • Locked
  • Question
304 stainless pitting issue - looking for source of chlorides
Replies
11
Views
650
EdStainless
EdStainless
Dusty Dave
  • Locked
  • Question
Failure of Wind Fence due to corrosion
Replies
4
Views
720
Tensile_test_my_spine
Tensile_test_my_spine
metaleng123
  • Locked
  • Question
Knife-line Attack prevention when welding 321 SS 1
Replies
11
Views
377
MFAMET
MFAMET
Saad M.M.
  • Question
Is ASTM A262, Practice E sufficient to ensure solution annealing of 316L stainless steel?
Replies
5
Views
3K
SK METT
SK METT
PRjuventus
  • Question
Interpreting of "thickness is the minimum dimension of the heaviest section"
Replies
0
Views
920
PRjuventus
PRjuventus

Part and Inventory Search

Sponsor

Back
Top Bottom