Hi all,
Yesterday I was loop checking a Temperature transmitter, I used fluke loop calibrator in measurement mode to check the milliamps in the marshalling panel, Other guy sourced the transmitter by putting rtd in the temp bath, I was getting the reading up to 50 percent(12ma), then my loop calibrator suddenly turned off, when I turned on it went to source mode then the display went off, now it is not working, what may be the reasons?
Yesterday I was loop checking a Temperature transmitter, I used fluke loop calibrator in measurement mode to check the milliamps in the marshalling panel, Other guy sourced the transmitter by putting rtd in the temp bath, I was getting the reading up to 50 percent(12ma), then my loop calibrator suddenly turned off, when I turned on it went to source mode then the display went off, now it is not working, what may be the reasons?
