Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

LPI Minimum dwell time of weld as per ASME

Status
Not open for further replies.
stan000

stan000

Mechanical
Jul 31, 2014
121

what is Minimum P.T.dwell time of weld as per ASME
I THINK As per ASME section V Table 2 STEEL MATERIAL ON WELD Penetrate time shows 5 min.
please let me know i am wrong or right.

regards
stanly
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Yes, it is 5 minutes per Table T-672 for metal temperature at 50 deg F to 125 deg F.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

FAHADRANA
  • Question
WQT for Combination of Welders as per ASME Sec IX
Replies
1
Views
2K
weldstan
weldstan
wdavidchris
  • Locked
  • Question
ASME IX - Minimum Groove Weld Thickness for Fillet Weld Qualification 1
Replies
8
Views
492
wdavidchris
wdavidchris
V
  • Question
Is pressure retaining fillet weld qualification by fillet weld possible under ASME IX. 2
Replies
3
Views
2K
IdanPV
IdanPV
mrpsi
  • Locked
  • Question
Qualifying A4-70 bolt per ASME B31.3
Replies
2
Views
328
mrpsi
mrpsi
Santiago Vacca
  • Locked
  • Question
Per B31.3 Impact test exemption of weld metal below (continuation of closed thread292-509093)
Replies
2
Views
304
Santiago Vacca
Santiago Vacca

Part and Inventory Search

Sponsor

Back
Top Bottom