Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Lua and FEMM 4.2

Status
Not open for further replies.

lieuthnant

Electrical
Sep 30, 2011
7
In the picture is on the right, a square of steel and left a sensor with Magnet. I would like to move and gradually at its original position the square forward near as possible to the sensor and backward. This must to be cyclically. For that, i wrote a Programm in Lua but it doesn't work. I add the program and FEMM sketch. Perhaps someone from you sees which mistake i make.
 
Replies continue below

Recommended for you

At first sight I understand your drawing is not complete. You should define properties concerning area between air and steel
Can you post your lua script?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor