Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Machining Devlon T100 plastic

Thread starter gb433054
Start date Sep 4, 2003

Status: Not open for further replies.

Sep 4, 2003

gb433054

Aerospace

Does anyone have any experience of machining Devlon T100 plastic. I am particularly interest in recommended surface speeds, feed per tooth etc for use with carbide cutting tools. And also deep hole drilling (upto 400mm)

Any help would be appreciated