Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Macro for adding revision table to every sheet in UGNX 9.0

Thread starter sunil shetty
Start date Feb 14, 2017

Status: Not open for further replies.

Feb 14, 2017

sunil shetty

Mechanical

Hi,

I need a macro/journal in vb that should add new row to existing revision table on each sheet and update with user specified details. I tried recording journal to copy last row of existing revision table and pasting it below last row but it was not recorded.

I appreciate any comment in this regard.

Thank you