Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Macro for point creation on a curve in catia v5

Thread starter ankit.P
Start date Dec 25, 2022

Status: Not open for further replies.

Dec 25, 2022

ankit.P

Student

Hello,
I am working on a project for creating a macro which can tell us whether the given hole on a surface is circular or not..
If anyone can help me in this it would be really helpfull.
I don't have access to the group for catia V5 if anyone does you can post it over there.
Thanks