Macro for replacing parameters

[VojtaR]

Hello,

Could anyone help with writing a macro?
I have list of external parameters e.g. 01_length; 02_angle... then I have a second group of parameters: example_01_length; example_02_angle... I would like to select 01_length run macro
Macro should do: replace 01_length with example_01_length; 02_angle with example_02_angle and so on.

Thank you for your help.

 

[Little Cthulhu]

Hi.

Parameter replacement (and almost any replacement routine in general) is not possible with macro.

 

[ferdo]

Hi

Modify like below yes, replace...I don't think...

https://youtu.be/EfPY9OYDP9Y

[youtube

https://youtu.be/EfPY9OYDP9Y

]


Regards
Fernando

https://www.youtube.com/playlist?list=PL9mSHa4SOedV3dr0D3kfIWFUg7mIYm94k