I have a question about recording a macro in SW 2014. I have a part that I insert component and then use the smart mates to put it in the assembly. The insert component part of the macro works, but it never makes the smart mates correctly. Any hints on how to make that work? when I make the recording everything lines up where it should.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Macro on smart mates
- Thread starter fish52
- Start date
Similar threads
- Locked
- Question
- Question