Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Macro on smart mates

Thread starter fish52
Start date Jul 23, 2014

Status: Not open for further replies.

Jul 23, 2014

fish52

Automotive

I have a question about recording a macro in SW 2014. I have a part that I insert component and then use the smart mates to put it in the assembly. The insert component part of the macro works, but it never makes the smart mates correctly. Any hints on how to make that work? when I make the recording everything lines up where it should.