fornhamspark
Electrical
- Oct 23, 2004
- 44
I recently had some experiance with Eurotherm / Parker 690 VSD drives. To run in Vector control it required a auto tune. But the autotune had to be selected to perform this in stationary mode due to the load. If autotune in stationary mode the drive required the magnatizing current from the manufacturer.
Basically my question, is there a way to calculate this from the name plate if it isn't stamped on the plate?
Manufacturers why do you not put this information on?
Basically my question, is there a way to calculate this from the name plate if it isn't stamped on the plate?
Manufacturers why do you not put this information on?