Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Magnet Controller

Thread starter zaphod1
Start date Nov 9, 2003

Status: Not open for further replies.

Nov 9, 2003

zaphod1

Electrical

Hi, Can anyone direct me to a manufacturer of a magnet controller for an electromagnetic chuck in a surface grinder? The magnet is rated for 225Vdc and 10 amps. I would like to be able to adjust magnetism from an analog output of a PLC. I will also need to be aable to demag. with the same controller.
Thanks,