Aug 31, 2011 #1 cook206 Aerospace Apr 27, 2011 7 How do I change a dimension manually using NX 7.5? I'm trying to change the dimesions to letters in order to reference a cutout in a table elsewhere.
How do I change a dimension manually using NX 7.5? I'm trying to change the dimesions to letters in order to reference a cutout in a table elsewhere.
Aug 31, 2011 1 #3 ewh Aerospace Mar 28, 2003 6,141 The first time you attempt this, a warning box will appear asking if that is really what you want to do. You can then turn that box off for future edits. "Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small] Upvote 0 Downvote
The first time you attempt this, a warning box will appear asking if that is really what you want to do. You can then turn that box off for future edits. "Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]
Aug 31, 2011 Thread starter #4 cook206 Aerospace Apr 27, 2011 7 thank you both for your replies but are you using 7.5? That is how I used to do it. It doesn't seem to work in 7.5. Upvote 0 Downvote
thank you both for your replies but are you using 7.5? That is how I used to do it. It doesn't seem to work in 7.5.
Aug 31, 2011 1 #5 JohnRBaker Mechanical Jun 1, 2006 35,864 Worked for me using NX 7.5, as mmauldin described it. John R. Baker, P.E. Product 'Evangelist' Product Design Solutions Siemens PLM Software Inc. Industry Sector Cypress, CA http://www.siemens.com/plmhttp://www.plmworld.com/museum/ To an Engineer, the glass is twice as big as it needs to be. Upvote 0 Downvote
Worked for me using NX 7.5, as mmauldin described it. John R. Baker, P.E. Product 'Evangelist' Product Design Solutions Siemens PLM Software Inc. Industry Sector Cypress, CA http://www.siemens.com/plmhttp://www.plmworld.com/museum/ To an Engineer, the glass is twice as big as it needs to be.
Aug 31, 2011 Thread starter #6 cook206 Aerospace Apr 27, 2011 7 Thanks everyone! I was selecting the dimension first. I needed to select it after the commands. Worked! Thanks again! Upvote 0 Downvote
Thanks everyone! I was selecting the dimension first. I needed to select it after the commands. Worked! Thanks again!
