Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Manufacturing standards for Cross Recessed Undercut Screws 2

Status
Not open for further replies.
hinged

hinged

Mechanical
Jun 6, 2002
22
I'm looking for more information than supplied in the IFI Standards book for manufacturing tolerances and dimensions for cross recessed( #3 phillips) undercut flat countersunk head tapping screws. PLease direct me to other sources if available.
Thank you
hinged
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Try ISO 7046-1 and the other standards to which it refers.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

L
  • Question
SA 350 Flange Manufacturing
Replies
7
Views
4K
lt34
L
S
  • Question
Software for Material Engineers
Replies
4
Views
2K
Saman2002
S
ShabsRBI
  • Question
Burst Calculation for Boiler Steam Drum for RBI model
Replies
1
Views
2K
BEMPE16524
BEMPE16524
C
  • Question
Valve selection for phosphoric acid
Replies
0
Views
948
chok7
C
kangomath
  • Question
Stainless stell for high temperature 2
Replies
4
Views
1K
ShabsRBI
ShabsRBI

Part and Inventory Search

Sponsor

Back
Top Bottom