Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mass property calculations

Thread starter cadmate
Start date Dec 17, 2007

Status: Not open for further replies.

Dec 17, 2007

cadmate

Mechanical

Hi everyone, has anyone seen this message before 'mass property calculations could not match requested accuracy' It gives me the option to Cancel or Accept, which i have to accept twice before i can move on
It has just started popping up every time i save an assembly which has less than 200 parts (does not yet happen on other assenblies).
Running Inventor 2008 Pro, Win XP Pro, 4gb ram, Nvidia quadro 1500 fx.
Many thanks