Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Material table

Status
Not open for further replies.
cubalibre000

cubalibre000

Mechanical
Jan 27, 2006
1,070
Hi,
someone use personalized material table located in sheet_metal_material_table.txt ?
We produce lot of sheet metal part and I would automatize the process to calculate the correct flat-pattern.
At the moment we put manually the k-factor, but maybe an useful table improve and reduce errors.
Can someone link some yours files ?

Thank you...

Using NX 7.0.1.7 MP3 and TC8.1
 
Status
Not open for further replies.

Similar threads

johnny777886
  • Locked
  • Question
NX2206 Hole Table Numbers Reset
Replies
0
Views
152
johnny777886
johnny777886
El_Paben
  • Locked
  • Question
Material color
Replies
3
Views
92
jerry1423
jerry1423
CADologist
  • Locked
  • Helpful tip
NX Journal - Assign Material to All bodies in part; Assign Description to "Description Attribut 1
Replies
0
Views
334
CADologist
CADologist
Ozcar
  • Locked
  • Question
conversion of material databse for StarCCM and AmeSim
Replies
0
Views
90
Ozcar
Ozcar
MANox
  • Locked
  • Question
Material attribute by expression
Replies
0
Views
100
MANox
MANox

Part and Inventory Search

Sponsor

Back
Top Bottom