Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Maximum content of an element in material 2

Status
Not open for further replies.

lesnar

Mechanical
Jul 14, 2010
4
Hi,

This is my first post here.

If an ASTM standard material specifies max content of an element (say 0.5% of molybdenum), then can the content of that element in the material be accepted as zero? Or is it mandatory for some percentage of that element to be present in the material?
 
Replies continue below

Recommended for you

In other words, can an element with a maximum specified limit and no minimum limit not be present? The reply is yes.
 
Thank you metengr, that answers my question.
 
metengr, I have one more question.
The material specification doesn't say anything about a element (e.g. Nitrogen), but the received MTC for that material has some percentage of Nitrogen.
Is it still acceptable?
 
lesnar,
You can look this in a bit wider scope also.
I suggest that you read A751.

= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
 
Yes it is acceptable. Additional elements can be reported for information purposes if they are not specified by limits imposed by the material specification.
 
As long as the added element does not actually qualify it as another alloy and it has no significant impact on properties.
You can add unspecified elements for processing reasons, but if they change the grade or properties it is not allowed.

= = = = = = = = = = = = = = = = = = = =
P.E. Metallurgy, Plymouth Tube
 
Thank you metengr and EdStainless for your replies.

I checked the minimum tensile / yield strengths and elongations of the supplied material (one with additional elements) and it meets the requirements of the material specification.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor