Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mazak Cut Conditions

Thread starter ksbarlow67
Start date Nov 7, 2019

Status: Not open for further replies.

Nov 7, 2019

ksbarlow67

Industrial

Hey everyone, New here to this forum.
Currently I am trying to cut some .012 304 Stainless Steel using a Mazak Hyper Turbo x 510 and i was wondering if anyone had cut conditions for that thin of material for the slow cut condition. Any help is greatly appreciated.