Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

measure accl rate on dyno?

Status
Not open for further replies.

CurtisBoggs

Automotive
Aug 23, 2004
11
0
0
US
Is there a way to measure, or get an indication of an engine's acceleration rate on the Superflow 901 with the basic console??

Tested an engine that was a second a lap faster on a road course, but showed no difference on the dyno???

Curtis

Curtis Boggs
Racing Flow Development
 
Replies continue below

Recommended for you

When you mean no difference between the engines on the dyno, do you mean that they had the exact same torque curves or just had the same peak numbers? I would think to see different acceleration characteristics between engines you would see some difference in the torque curves between the two. If not then I would look elsewhere for your improved lap times.

I have had only limited experience with the 901 and can't think a good way to measure acceleration with it but maybe someone else can.

Neil
 
There was two tests on two different dynos on the same heads & shortblock.

One a Studska the other a Superflow. Both results the same.

The torque & HP curves are the same, .. .. but one is faster on the track??

The only difference was the faster cylinder head had 2-3 points more BSFC at the same 1280 a/f.

brain teaser, ..

Curtis



Curtis Boggs
Racing Flow Development
 
The only difference was the faster cylinder head had 2-3 points more BSFC at the same 1280 a/f.

brain teaser, ..
===============================

2-3 points ,..you mean .450 -vs- .480 ???

1280 A/F Ratio , you mean 12.80:1 Air/Fuel Ratio ???



Larry Meaux (maxracesoftware@yahoo.com)
Meaux Racing Heads - MaxRace Software
ET_Analyst for DragRacers
Support Israel - Genesis 12:3
 
Larry.

The BSFC for the fast head was .540 at 4500 to .630 at 6750
in the mid rpm range 5200 was .540 6250 .610

The "slower" head was .52 at 4500, .. .63 at 6750,
mid rpm range, 5200 .53 6250 .60

a/f is 12.80:1, . . . . CDS wide band, bosch lsm11 sensor.

Curtis



Curtis Boggs
Racing Flow Development
 
Status
Not open for further replies.
Back
Top