Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Measuring an internal taper using a capacitive sensor or LVDT

Status
Not open for further replies.
johnmchughdolan

johnmchughdolan

Mechanical
May 29, 2015
1
How would you go about measuring an internal taper if the only equipment you have available is a capacitive sensor and a LVDT? Measurement could be taken directly or indirectly.
 
Status
Not open for further replies.

Similar threads

Bouta
  • Locked
  • Question
Measuring small deformation caused by temperature?
Replies
3
Views
2K
3DDave
3DDave
tk90
  • Question
"QTM" or "PTM" Test Standards?
Replies
1
Views
4K
tk90
tk90
Leo_IWI_EWI_MSc_BSc
  • Locked
  • Question
Boat or Scoop Test
Replies
4
Views
3K
weldstan
weldstan
C
  • Question
Modification of an EN 12952 certified boiler
Replies
0
Views
1K
carrabta
C
Josh Blank
  • Locked
  • Question
Using an O-Ring to seal on an NPT lead chamfer - Design Improvement Ideas
Replies
10
Views
1K
Tmoose
Tmoose

Part and Inventory Search

Sponsor

Back
Top Bottom