Mesh problem 1

[Ripper2009]

Hi all.

Co-worker has not used his SW in about a year, and has SW 2005 SP 0.0.
He is testing a part, all goes well, however, when he tries to mesh the part, he gets the message " Mesh Not Created" and prompts him to click OK. He clicks OK, the graphics goes back to where he started before he tried the mesh.

Ive check - -no answer.

Can anyone advise?

Thanks,

Rip


SolidWorks 2007
SP 4.0

 

[cbrn]

Hi,
start over the entire CosmosWorks study (you can create a new studyt and then copy-paste the boundary conditions you had already defined in the previous study, if any). It frequently helps whenever for some reason the CW database is "mis-synchronized" with the SW one.

Regards

 

[Ripper2009]

Thanks cbrn!!

I really appreciate the advice.

Thanks,

Rip


SolidWorks 2007
SP 4.0