Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Meshing in Pro/Mesh

Status
Not open for further replies.
ng

ng

Mechanical
Jun 23, 2001
28
0
0
IN
Dear Friends
I want to mesh an assembly having 4 -5 components using Pro/Mesh. My Problem is, "there is gap between two components (in microns)".Can i use Gap element type of things in pro/Mesh.
If yes? Then How?

Nikhil Gothankar
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

pmbov
  • Locked
  • Question
Creo 10 Pro/program Problems
Replies
7
Views
53
3DDave
3DDave
Designer_D
  • Locked
  • Helpful tip
Original Pro/Engineer Blue Background Color Values (thread554-165973)
Replies
0
Views
31
Designer_D
Designer_D
mattmyer
  • Locked
  • Question
Font Problems in Creo drawings
Replies
2
Views
36
dgallup
dgallup
S MORIN
  • Locked
  • Question
ptc_material_description in a note
Replies
0
Views
29
S MORIN
S MORIN
Milan Martikan
  • Locked
  • Question
NWF file generator for facilitating routing in PTC Creo Cabling
Replies
0
Views
33
Milan Martikan
Milan Martikan
Back
Top