Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Meshing with CTETRA 10 - Failed elements

Status
Not open for further replies.

Zeck

Mechanical
Jan 2, 2014
38
Hello,

I am meshing a CAD model with CTETRA 10 elements with Midnode method Linear to avoid Failed elements. Afterwards I use 2D Mesh in certain areas for refinement with Midnode method Mixed. Then I still have Failed elements especially regarding Edge Point Included Angle.
I would like to ask you for help.

Best regards
Zeck
 
Replies continue below

Recommended for you

In the CAD model
(pull down) Menu -> Analysis -> Examine Geometry
all the checks should be toggled on, then select the model with a rectangle, and press "Examine Geometry" on the bottom



Jerry J.
UGV5-NX1884
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor