Message during closed part

[cubalibre000]

Hi,
when I close an assembly, the message appear when I close the assembly.
Can I avoid this message ?
If the assembly contain a lot of parts....this message become very, very annoying.

We make a workflow (revision) of single parts or little assembly, not the main assembly that remain writable.

Solutions ?

Thank you...

Using NX7.0 and TC8.1

 

[pracslipkerm]

Try changing preference (File menu -> Utilities -> Customer Defaults -> Gateway section -> User Interface -> Alerts tab and then clear alerts.
You may need to change Defaults Level if it is read only, look up the top of the dialog.
I'm not sure if this will help or not but might be worth trying.

Cheers
Steve Griffiths

If you want to make apple pie from scratch, first you must create the universe!

 

[cubalibre000]

Sorry, but I' don't have this tab.
I'm using NX7.

Thank you...

Using NX7.0 and TC8.1

 

[JohnRBaker]

I don't have that 'tab' either. However, I think what you're looking for is at...

Customer Defaults -> Assemblies -> General -> Miscellaneous

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

Hi John....thank you...this is the option that I was looking for.

Thank you...

Using NX7.0 and TC8.1