Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Metal Cutting Simulation (Explici - ABAQUS or LS-DYNA)

Thread starter WPZ
Start date May 4, 2014

Status: Not open for further replies.

May 4, 2014

WPZ

Mechanical

Hi Guys,

I need to performance one Metal Cutting Simulation using FEA and I would like to know if someone has this kind of knowledge. In fact, I know I have to use the EXPLICIT mode and the better for it are ABAQUS and LS-DYNA. There some technical papers showning ALE method, SPH method, and etc. Academics people like more Abaqus, but the Explicit mode of LS-Dyna is most used (Crash tests, for example).
Boths are great software, but I am looking for the best one!

Thank you very much.

Wagner