Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

METAL INJECTION MOLDING

Thread starter PedroArrochella
Start date Sep 6, 2004

Status: Not open for further replies.

Sep 6, 2004

PedroArrochella

Mechanical

I do mainly plastic injection mold but at this moment I´m doing a four cavity mold for Al injection and finding very dificult to obtain a calculation procedure for the runner and gate, can anyone advise some literature for MIM?

Best regards
Pedro Lobo