Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Method to find Pressure drop for knife gate valve

Status
Not open for further replies.
kishoredevadoss9704

kishoredevadoss9704

Mechanical
Mar 23, 2015
14
Heloo,
Kindly suggest pressure drop calculation for knife gate valve metal seat #150 ,inlet port 8"and Media is pulverized coal .

Thanks in advance
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The pressure drop across a fully open knife gate valve is very little. The hole when open is much the same as the pipe it is connected to.

URL]
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

turbo05
  • Question
Suggestion for Square thread Stemnut of a non-rising stem gate valve
Replies
0
Views
225
turbo05
turbo05
deepu78
  • Locked
  • Question
Isolation Valve Syngas Gate vs BALL 1
Replies
5
Views
334
deepu78
deepu78
Krausen
  • Locked
  • Question
Gate Valves in HF Acid Service
Replies
1
Views
334
acdxxx177
acdxxx177
nihili
  • Locked
  • Question
Throttle valve for high pressure steam
Replies
0
Views
95
nihili
nihili
yamoffathoo
  • Locked
  • Question
How does a 8" Crane 465.5 Gate Valve Stem Separate ? (cast iron gate & manganese bronze ste
Replies
4
Views
168
yamoffathoo
yamoffathoo

Part and Inventory Search

Sponsor

Back
Top Bottom