Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

mf1 file & NX 8

Status
Not open for further replies.

ilovedividends

Industrial
Dec 1, 2013
41
I am new to NX. I have an old hard drive with some useful designs on it. All the files are mf1 & mf2. Is it possible to get these into NX 8.

Thanks
 
Replies continue below

Recommended for you

No, I just have the mf1 & mf2 files on the hard drive. If I need I-deas is there any way to get it functional enough to get these files into NX(trial version)?
 
If you can get I-Deas running you could always export out a step, iges and or a Parasolid file of your models out of I-deas. Then you can import your models into NX. Are you running teamcenter? And of course these models will be non history supported just solid bodies when imported into NX.
 
Oh you could also you file interoperate and export out an XPK file.
 
I am not running teamcenter. Can you get these mf files into NX without SDRC IDEAS?
 
You may want to send these to GTAC. They may be able to do something with them.
 
All NX customers can have a free version of IDEAS [thumbsup2], ask to your local contact
I have NX6 to NX9 and Ideas NXI2


Regards
Didier Psaltopoulos
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor