Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mig Weld

Status
Not open for further replies.

dwoody1

Mechanical
Feb 25, 2003
23
US
I am trying to find documentation of minimum weld penatration by percent for saftey welds, etc. Is there such a document?
 
Replies continue below

Recommended for you

Your question is too vague.
Some welded joints are designed for partial penetration and in those cases the depth of weld will be clearly specified. If not specified, you must assume full penetration is required.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top