kukelyk
Industrial
- Mar 21, 2005
- 315
What is the simpiest way to do this?
In the attached prt, there are 2 programs,
A false, where the cut depth is not constant, and
a correct one, where the cut depth is OK, but it needed some auxiliary geometry.
But, in a normal mold part, it is very hard to generate such offset faces..
thanks in advance.
----
kukelyk
In the attached prt, there are 2 programs,
A false, where the cut depth is not constant, and
a correct one, where the cut depth is OK, but it needed some auxiliary geometry.
But, in a normal mold part, it is very hard to generate such offset faces..
thanks in advance.
----
kukelyk