LMGK
Automotive
- Dec 23, 2004
- 17
Hi all, i want to do miners rule analysis for gear. So that i have the following input parameters:
1. number of teeth (14)
2. Heat treat : case carburized
3. Operating torque
4. Operating speed
5. Operating time
6. Operating stress
7. Allowable stress
with those parameters, would like to know the following output parameter values:
1. Operating cyles
2. Cycles to failure
3. Life factors
4. Cycle ratio
could anyone provide me the formulas for the above output parameters with the above input variables.
thanks
1. number of teeth (14)
2. Heat treat : case carburized
3. Operating torque
4. Operating speed
5. Operating time
6. Operating stress
7. Allowable stress
with those parameters, would like to know the following output parameter values:
1. Operating cyles
2. Cycles to failure
3. Life factors
4. Cycle ratio
could anyone provide me the formulas for the above output parameters with the above input variables.
thanks
