Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Minimum Bend Radius 1

Status
Not open for further replies.

LPPE

Structural
Joined
May 16, 2001
Messages
578
Location
US
Specifically, what is the minimum bend radius for an MC12x31 flanges out?

Generally, is there a rule of thumb for bend radii? For the "easy way", flange width (in.) X 2 in feet, perhaps?
 
Yes, a good article. However, they stop short of rules of thumb or any specific radii values.
I'm hoping someone out there may have experience in bending MC's flange out. The architect wants a 6'-8" radius, and I'm not sure if thats possible.
Thanks.
 
There are usually 4 or 5 steel fabricator advertisements in each issue of Modern Steel that say they specialize in bending steel. Call one of them or your local fabricator. They should be happy to answer your questions so they can sell more of their product.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top