Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Minimum Web Lenght

Thread starter cubalibre000
Start date May 16, 2011

Status: Not open for further replies.

May 16, 2011

cubalibre000

Mechanical

Hi,
as the image attached, I would like to set the Minimum Web Lenght after setting the material.
In the sheet_metal_material_table I set thickness, bend radius and k-factor.
If in this file I'm not able to set the Minimum Web Lenght, exist a workaround or some type of solution to set automatically ?
It's possible ?

Thank you...

Using NX 7.0.1.7 MP3 and TC8.1