Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
mirror a part and save it separately. 1
- Thread starter mrmopar
- Start date
-
1
- #2
I assume that you want to create a new part which is mirrored to an existing part.
1. Create a new file then click the Insert Part Copy.
2. Select the file which is to be mirrored.
3. The part will be copied to the file.
4. On the Ribbon Bar click the Parameter Step.
5. Check the Mirror Body in the Part Copy Parameter Dialog Box.
6. Select the appropriate plane to mirror the part.
This will do the trick.
1. Create a new file then click the Insert Part Copy.
2. Select the file which is to be mirrored.
3. The part will be copied to the file.
4. On the Ribbon Bar click the Parameter Step.
5. Check the Mirror Body in the Part Copy Parameter Dialog Box.
6. Select the appropriate plane to mirror the part.
This will do the trick.
- Status
