Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mirror a sheet metal part?

Thread starter Akesson
Start date Mar 11, 2003

Status: Not open for further replies.

Mar 11, 2003

Akesson

Mechanical

If only one half of the model is created in "Sheet Metal Design" and then the mirror command is used in "Part Design" only the first half is shown if the unbend command is used.

Anyone who have any idea how to use mirror command with sheet metal parts or do you really have to modell the complete part if it's symmetric?