Mar 3, 2010 #1 mecram1 Mechanical Mar 12, 2008 9 What is the best way to mirror parts with bolted connections within an assembly (Inventor 2010)?
Mar 3, 2010 #2 EngAddict Mechanical Oct 1, 2009 410 I try not to mirror parts in assemblies, can't remember the last time I used it. Can you try to pattern the bolted connections instead? Upvote 0 Downvote
I try not to mirror parts in assemblies, can't remember the last time I used it. Can you try to pattern the bolted connections instead?
Mar 3, 2010 Thread starter #3 mecram1 Mechanical Mar 12, 2008 9 Unfortunetly autodedesk does not let you pattern a bolted connection. I can pattern a point and then use the bolted pattern on the points but most of my bolt placements don't follow pattern. Upvote 0 Downvote
Unfortunetly autodedesk does not let you pattern a bolted connection. I can pattern a point and then use the bolted pattern on the points but most of my bolt placements don't follow pattern.
Mar 4, 2010 #4 EngAddict Mechanical Oct 1, 2009 410 Since when? I can. You are better off to use pattern by holes anyway because a bolted pattern does not pattern holes if you use the BC to create the hole. Upvote 0 Downvote
Since when? I can. You are better off to use pattern by holes anyway because a bolted pattern does not pattern holes if you use the BC to create the hole.
