Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Missing bend notes on instance drawings?

Status
Not open for further replies.

gandytable

Mechanical
Joined
Dec 13, 2001
Messages
50
Location
US
I have a large table of sheet metal parts. Drawings are set up to show bend angle and direction by using "show" and "notes". Some instances have a lot of bends (complex parts) and some instances have supressed bends (simple parts). I will save a copy of an instance drawing (simple part)to another instance part number (complex part) and replace the model with the proper model, to save detail time. I will add bend notes by using "show" to a drawing with more bends (complex part)that other instances (simple parts) do not have. (I sometimes use erase, and not delete if I go from a complex part drawings to a simple part drawing.) I can then close and open the (complex) drawing with no problems, as long as no other drawings are open. But, when I open a complex drawing and then open a simple family instance part drawing that is missing some bends, then when I go back to the complex part drawing the bend notes for those bends are missing. What can I do to save the bend notes and still use family tables for varied parts and drawings?
 
Found a solution. Installed datecode M180 for Wildfire 1, and the problem has not reoccured.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top